Welcome Visionstream contractors!

These courses have been specifically set up for Visionstream contractors to complete their mandatory compliance training. Below you will find locations, dates and costs for each course.

Gas Test Atmospheres

Unit:
MSMWHS217 – Gas test atmospheres
Duration: 5 Hours
Cost: $95.00 (GST Exempt) – this course is normally $150 – contact Vision Stream for the discount code to access the special pricing

For further information on this course, please visit https://www.jbhunter.edu.au/product/gas-test-atmospheres/

Working Safely at Heights

Unit: RIIWHS204D Work safely at heights
Duration: 1 Day
Cost: $220.00 (GST Exempt)

For further information on this course, please visit https://jbhunter.edu.au/product/working-at-heights/

NULCA Underground Asset Location

Unit: RIICCM202E – Identify, locate and protect underground services
Duration: 2 Days
Cost: $765.00 (GST Exempt)

For further information on this course, please visit https://jbhunter.edu.au/product/underground-asset-locator/

HSE Yearly Refresher Training

Accredited Units:

HLTAID001– Provide cardiopulmonary resuscitation
UETTDRRF10B– Provide first aid in an ESI environment
UETTDRRF02B– Perform pole top rescue
UETTDRRF06B – Perform rescue from a live LV panel
UETTDREL14A – Working safely near live electrical apparatus as a non-electrical worker
UETTDRRF01B– Apply ESI safety rules, codes of practice and procedures for work on or near electrical apparatus
UETTDRRF09B– Apply access procedures to work on or near electrical network infrastructure

Non-Accredited Units:

JBHT-01VSTC – VESI Safe to climb
JBHT -01WWL – Working with ladders
JBHT-01WAP – Working at poles

Duration: Online learning and knowledge assessment, plus 1 Day face to face
Cost: $250.00 (GST Exempt)

For further information on this course, please visit https://jbhunter.edu.au/product/hsei-hse-interim-year-refresher-program/

FIBRE TECHNICIAN – aligns to nbn™ ENABLE 8, 10, 11 ACCREDITATIONS

Units:

ICTTEN310 Remove and replace electronic circuit boards in carrier equipment (nbn Skill 8)
ICTTEN409 Commission an electronic system (nbn Skill 10)
ICTTEN416 Install, configure and test an internet protocol network (nbn Skill 11)
Duration: 3 Days
Cost: $750.00 (GST Exempt)

Optical fibre splicing course

This course meets the requirements for nbn™ technical skill accreditations:

Skill 9 – Fibre inspection and cleaning;
Skill 13 – Fibre splicing

Units:
ICTCBL330 – Splice and terminate optical fibre cable for telecommunication projects

ICTTEN318 – Inspect, clean and handle optical fibre cable and connectors
Duration: 5 Days
Cost: $1100 (GST Exempt)

Implement Traffic Management Plan – Victoria

THIS TRAINING IS DELIVERED AND ASSESSED BY ALERTFORCE (RTO NUMBER 91826)

Unit: RIIWHS302D Implement traffic management plan
Duration: 1 Day
Cost: $310.00 (GST Exempt)

In Victoria, this is a one (1) day course. Assessment will require satisfactory completion of a written test and a series of practical demonstrations.

Upon successful completion you will receive a Statement of Attainment in RIIWHS302D Implement traffic management plan (Issued by Alertforce RTO ID 91826).

Implement Traffic Management Plan – New South Wales

THIS TRAINING IS DELIVERED AND ASSESSED BY ALERTFORCE (RTO NUMBER 91826)

Unit: RIIWHS302D Implement traffic management plan
Duration: 1.5 Days
Cost: $440.00 (GST Exempt)

In New South Wales, this is a one and a half (1.5) day course in which all students must be assessed on a minimum of three (3) site set-ups. We have allocated 1.5 days for this course, so that all three (3) set-ups can be done under the Supervision of a suitably authorised person (i.e. Trainer). Course costs are inclusive of Safe Work NSW fees.

Upon successful completion you will receive a Statement of Attainment in RIIWHS302D Implement traffic management plan (Issued by Alertforce RTO ID 91826).

Implement Traffic Management Plan – Queensland

THIS TRAINING IS DELIVERED AND ASSESSED BY CURRENT TRAINING (RTO NUMBER 5768)

Unit: RIIWHS302D Implement traffic management plan
Duration: 1 Day for those with access to a traffic management site, OR 1.5 days for those needing to complete all three (3) sites at the training (further details below)
Cost: $330.00 (GST Exempt) for the 1 day course OR $450.00 (GST Exempt) for the 1.5 day course

In Queensland, this a one-day training course and includes a simulated site set-up. You are required to do two additional set-ups. This can be done on a suitable site and signed off by an authorised Supervisor. If this applies to you, then book into the one-day course. NOTE- You should only select the one day course if you have access to a suitable site and supervisor.

If you do not have the ability to do the additional set-ups on a suitable site, we can supervise them in the classroom for you. This requires an extra half day. If this suits you best, then please book into the one and a half day course.

Please note that – separate to this training – you are required by Transport and Main Roads (TMR) to complete two online training programs “Working Proximity to Traffic Part 1 and 2”. You can complete these online courses during the 3-month period allowed for the completion of the 3 mandatory signage setups.

You will need to go to the following Web Link pay the required TMR fees (an additional $79.20 paid directly to TMR), complete the online courses, print the course certificates at completion and send a copy to JB Hunter:
https://learn.accelerate.tmr.qld.gov.au/blocks/androgogic_catalogue/index.php?q=proximity

Part 1 Key Information
https://www.tmr.qld.gov.au/-/media/busind/businesswithus/Traffic-Management/Work-Proximity-Traffic-Awareness-Keyinfo-Part1.pdf?la=en

Part 2 Key Information.
https://www.tmr.qld.gov.au/-/media/busind/businesswithus/Traffic-Management/Work-Proximity-Traffic-Awareness-Keyinfo-Part2.pdf?la=en

Upon successful completion you will recieve a Statement of Attainment in RIIWHS302D Implement traffic management plan (issued by Current Training RTO ID 5768).

For further information on this course, please visit https://www.currenttraining.edu.au/main-roads-accreditation-qld/#1506836106723-89cbfe62-1f64e1af-276d

For One Day QLD Course Bookings – Please Book Here

For One and a Half Day QLD Course Bookings – Please Book Here

HFC Network Technician – nbn enAble 18a Accreditation

Units:
ICTRFN401 Conduct radio frequency measurements
ICTRFN406 Maintain hybrid fibre coaxial broadband cable network
ICTTEN201 Use electrical skills in telecommunications work
ICTTEN302 Install telecommunications network equipment
ICTTEN409 Commission an electronic system
ICTTEN410 Locate, diagnose and rectify faults

Duration: 10 Days

Cost: $2500.00 (GST Exempt)